Franke FBI 537 XS Instrucciones Para El Uso Y La Instalacion página 10

When installing the Ducting version, join the Hood
to the outlet duct using a rigid or flexible pipe ø150
or 120 mm, selection of which is at the discretion of
the installation technician.
• Insert flaps 11b on the Hood Canopy Outlet.
Connecting the ø 150 pipe
• Fasten the pipe using suitable pipe clamps. The
materials required to do so are not provided.
Connecting the ø 120 pipe
• To connect using a ø120 mm pipe, insert the re-
duction Flange 9 onto the Hood Canopy Outlet.
• Fasten the pipe using suitable pipe clamps. The
materials required to do so are not provided.
• In both cases, any Activated Charcoal Filters
must be removed.
• Cut a hole ø 125 mm in any shelf that may be po-
sitioned over the hood.
• Insert the reducer flange 9 on the hood body out-
let.
• Connect the flange to the outlet on the shelf over
the hood by using a flexible or rigid pipe ø120
mm.
• Fix the pipe in position using sufficient pipe
clamps (not supplied).
• Fix the air outlet grid 8 on the recirculation air
outlet by using the 2 screws 12e (2,9 x 9,5) pro-
vided.
• Ensure that the activated charcoal filters have
been inserted.
• Connect the hood to the mains through a two-pole switch having a contact gap of at least 3
mm..
EN
12e
ø 125
8
9
10
10