Franke FBI 537 XS Instrucciones Para El Uso Y La Instalacion página 11

L T1
S1
L
Button Led
L
-
T1
Fixed
T2
Fixed
-
T3
Fixed
-
T4
Fixed
S1
Fixed
Flashing
EN
T2 T3 T4
T1 T4
T2 T3
Function
Turns the lights on/off at maximum strength.
Turns the motor on/off at speed one.
Turns the Motor on at speed two.
Press and hold the button for approximately 3 seconds, with all the loads
turned off (Motor and Lights), to turn the Activated Charcoal Filter alarm
on. The relevant LED flashes twice to confirm.
To turn the alarm off, press the button again and hold for at least 3 seconds.
The relevant LED flashes once.
Turns the Motor on at speed three.
Press and hold the button for approximately 3 seconds, with all the loads
turned off (Motor and Lights), to perform a reset of Filter saturation alarm.
The LED S1 flashes three times.
Turns the Motor on at INTENSIVE Speed.
This speed is timed to run for 6 minutes. At the end of this time, the system
returns automatically to the speed that was set before. If it is activated with
the motor turned off, the hood will switch to OFF at the end of the time.
Signals the Metal Grease Filter saturation alarm, indicating that it is
necessary to wash the filters. The alarm is triggered after the Hood has been
in operation for 100 working hours.
When this is activated, it signals the Activated Charcoal Filter saturation
alarm, indicating that the filter must be changed; the Metal Grease Filters
must also be washed. The Activated Charcoal Filter saturation alarm comes
into operation after the Hood has been working for 200 hours.
S1
L
T1
T2
T3
T4
S1
11 11