Setting Remote Control Codes - Yamaha PianoCraft MCR-E810 Manual De Instrucciones

Controlling External Components

Setting remote control codes

You can control TVs made by other manufactures by
setting the appropriate remote control code (refer to "LIST
OF REMOTE CONTROL CODES" at the end of this
manual). Follow the procedures below to set the remote
control code.
STANDBY/ON
1 2
5 6
9 0
REPEAT
TV CH
MODE
TV INPUT
ON SCREEN
INFO.
A-E
SET UP
TV VOL
DISPLAY
DVD/CD
TAPE/MD AUX/TV
SUBTITLE ANGLE
48
En
POWER
TV
3 4
Number
7 8
keys
SCAN DIMMER
A-B
FREQ/TEXT
PROG
PROG
PTY SEEK
START
SHUFFLE
MENU
PRESET
ENTER A-E
TOP MENU
/RETURN
VOLUME
SLEEP
TUNER BAND
DOCK
AUX/TV
ZOOM AUDIO
1
Press AUX/TV to set the remote control to the
AUX/TV mode.
2
While holding down PROG
and then use the number keys to enter the
three-digit remote control code (refer to
"LIST OF REMOTE CONTROL CODES" at the
end of this manual) for the manufacturer of
your TV.
3
See "AUX/TV mode" on page 46 and try one
of the key operations for your TV to check
that the setting is working properly.
If the key operation does not work properly, the
remote control code may be incorrect. In this case,
perform step 2 again.
Notes
• Even if you set a remote control code, it will be cleared about
two minutes after the remote control batteries run out. In this
case, store remote control codes again after replacing the
batteries. (Be careful not to press the remote control keys while
replacing the batteries. Doing so may clear the settings.)
• If the manufacturer of your component has more than one code,
try each of them until you find the correct one.
press AUX/TV,
,