Shark RACE-R PRO GP 06 Manual De Instrucciones página 8

REMOVING THE INTERIOR PARTS
- Turn your helmet over.
- Separate the two parts of the chin strap.
- Disassemble the neck roll, by disengaging
the plastic part from its housing (Fig. A).
- Detach the rear part of the lining (Fig. B).
- To finish, release the front lining support,
starting with one side (Fig. C) and withdraw
the lining.
- Unclip the two cheek pads (Fig. D) and slide
them along the chin straps to extract them.
WARNING! The interior padding is
critical to maintain the correct fit of
the helmet on your head. If you have any
doubt whatsoever regarding the removal
or replacement of the interior padding,
DO NOT USE YOUR HELMET. Contact
your retailer for assistance or advice.
NEVER use your helmet with any part of
the interior padding removed. The helmet
will not protect you in an accident.
WARNING! The polystyrene lining
and interior padding are critical to
properly fit your helmet on your head. An
improper fit could cause your helmet to
become dislodged in an accident, leaving
your head unprotected and resulting in
severe head injury or death. If you are
not sure that you properly replaced the
comfort padding, DO NOT USE YOUR
HELMET.
assistance or advise.
8
Contact your retailer for
A
B
C
D