Shark RACE-R PRO GP 06 Manual De Instrucciones página 9

REPLACING THE INTERIOR
PADDING
- Reposition the cheek pads by passing the
chin straps through the slit in the foam (Fig.
A) and clip all the studs from the two cheek
pads (Fig. B).
- Start the operation by sliding the plastic tabs
of the front of the head section in its housing
beginning with one side (Fig. C).
- Position the textile correctly. Reattach the
rear part.
- Raise the cheek pad by inserting the back
piece and then replacing the hooks on the
side parts one after the other (Fig. D). Check
that the headgear has been placed in the right
direction.
WARNING! The interior padding is
critical to maintain the correct fit of
the helmet on your head. If you have any
doubt whatsoever regarding the removal
or replacement of the interior padding, DO
NOT USE YOUR HELMET. Contact your
retailer for assistance or advice. NEVER
use your helmet with any part of the
interior padding removed. The helmet will
not protect you in an accident.
WARNING! The polystyrene lining
and interior padding are critical to
properly fit your helmet on your head. An
improper fit could cause your helmet to
become dislodged in an accident, leaving
your head unprotected and resulting in
severe head injury or death. If you are
not sure that you properly replaced the
comfort padding, DO NOT USE YOUR
HELMET. Contact
assistance or advise.
your retailer for
A
B
C
D
9