Evenflo Advanced Single Manual De Instrucciones página 10

TROUBLESHOOTING
Problem Possible Cause
Membrane not sealing
Flange insert not fully
seated into flange
Little to no
suction, cont.
Poor seal between breast
and flange
Suction setting too low
No batteries or low bat-
teries
Suction settings too high
High suction
Damaged diaphragm
Damaged diaphragm
Discomfort Suction settings too high
Using incorrect flange size
Not stimulating milk
release before expressing
Missing parts
Expressing
little to no milk
when using
Pumping after
the pump
breastfeeding
Not using pump as
intended
16
USA/Canada: 1-855-EFI-BABY (334-2229) • www.evenflofeeding.com
Action
Make sure valve and membrane are clean,
with no debris on the surface of the seal.
Make sure membrane lies flat against the
surface of the valve (Page 6 ).
Properly install flange insert (Page 8).
Reposition the flange to get a better seal.
Make sure flange seals directly onto breast
with no clothing between breast and flange.
(Page 9).
Turn the control dial clockwise for stronger
suction (PAGE 10).
Make sure fresh, brand-name batteries are
installed correctly (PAGE 7).
Turn the control dial counterclockwise for
lower suction (page 10).
Inspect diaphragm before each use, replace
damaged components.
Inspect diaphragm before each use, replace
damaged components.
Turn the control dial counterclockwise for
lower suction (page 10).
Using a flange that is too small or too large
can cause discomfort. See Flange Sizing
(Page 8).
Stimulate your milk release with massage
and hand expression before placing pump to
breast (page 9).
Ensure diaphragm, valve, and membrance are
properly assembled
Wait 45-60 minutes after breastfeeding
before pumping.
This is an occasional use pump, not intended
for daily use (see inside front cover).
For warranty information please contact us at USA/Canada: 1-855-EFI-BABY (334-2229), by
mail at Evenflo Feeding Inc., Attn. Consumer Resources, 9277 Centre Pointe Drive, Suite 160,
West Chester, OH 45069, or visit our website at www.evenflofeeding.com/warranty.
Still having problems? Our Parent's Ally Consumer Care Team can help.
Our Parent's Ally Consumer Care Team will work with you to determine what solutions we can
offer, in accordance with our policies.
USA/Canada: 1-855-EFI-BABY (334-2229) • www.evenflofeeding.com
17