Publicidad
Idiomas disponibles
Idiomas disponibles
COMPONENTS
1
Support bolt (Separator)
2
Support bolt extension (Separator)
3
Separator 20-105 mm
4
Puller bridge
5
Hydraulic spindle
6
Pressure piece / Extension
7
Puller legs 200 mm
8
Puller legs 150 mm
9
Puller legs 100 mm
10 Threaded sleeve (2/3-legged puller)
11 Twin head (3-legged puller)
12 Triple head (2-legged puller)
ATTENTION
Read the operating instructions and all safety instructions contained therein carefully before using the
product. Use the product correctly, with care and only according to the intended purpose. Non-
compliance of the safety instructions may lead to damage, personal injury and to termination of the
warranty. Keep these instructions in a safe and dry location for future reference. Enclose the
operating instructions when handing over the product to third parties.
FEATURES
This hydraulic puller set is the result of a long time research and development on the part of the
manufacturer. It provides traction of up to 10 tons. This product allows pulling off any type of ball
bearing, belt pulley, cog wheel and similar components. But the biggest advantage of this product is
the possibility to combine the hydraulic ram with all types of puller heads. This safes time, space and
weight when operating the tool. All these features make up a revolutionary tool, which has
experienced many industrial applications already.
SAFETY INFORMATIONS
The following safety precautions are necessary because breaking and hurling pieces of the pulled
components can lead to serious injuries.
•
Always wear safety goggles!
•
Always wear gloves!
•
Before carrying out the pulling operation, check the ram for a centered position so that its legs
and the separator cannot slip off.
SW-Stahl und Werkzeugvertriebs GmbH
5
d i e
Puller Set | hydraulic | 10 t
6
e
s
s
a r t S
h
c
s
m
e
R
Tel. +49 (0) 2191 / 46438-0
r e
F
ax +49 (0) 2191 / 46438-40
s
u
k r e
v
e
7
9
8
2
4 -
D
e
BGS 97729
L
d . l h
a t s
w
s
@
o f n i
: l i
Publicidad
