Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS
Separator
1. Before you start, you should read up on the tool's features. After that, assemble the puller.
2. Adjust the hydraulic ram respectively its plunger on the center of the component you want to pull
off. First, tighten the ram and its legs carefully around the knurling by hand to achieve an initial
tension. Now, the puller possesses enough initial tension. By turning the T-handle carefully
clockwise, you will be able to pull off the desired component.
3. In case of operating a machine with a longer shaft than usual, just apply the appropriate extension
rod and carry out the operation as described before without the need of any extra effort.
MAINTENANCE
•
After every use you should clean the tool and all its components from dirt, dust or spilled liquids
etc.
•
Store the tool in its plastic case after it has been cleaned properly.
•
Check the tool's operation in accordance to default values and whether hydraulic oil has leaked
from the ram. In this case, open the cover on top of the ram by turning it carefully counter-
clockwise, take the cover off and fill up some fresh hydraulic oil up. Close the cover and operate
the tool as described above.
SW-Stahl und Werkzeugvertriebs GmbH
5
d i e
Two legged puller
6
e
s
s
a r t S
h
c
s
m
e
R
Tel. +49 (0) 2191 / 46438-0
r e
F
ax +49 (0) 2191 / 46438-40
s
u
k r e
v
e
7
9
8
2
4 -
D
e
Three legged puller
L
d . l h
a t s
w
s
@
o f n i
: l i
Publicidad
