Selco Genesis 240 TLH Instrucciones De Uso página 19

5.0 TRANSPORT - UNLOADING
Never underestimate the weight of the equipment,
(see technical specifications)
Never make the cargo pass or leave it suspended
over people or things.
Neither let the equipment or the single unit fall, nor
put it down with force.
Once it has been removed from the packing, the
power source is supplied with an extendible belt
which can be used to move it in the hand or on the
shoulder.
6.0 INSTALLATION
Choose an adequate installation area by following
the criteria provided in Section "1.0 SAFETY" and
"2.0 ELECTROMAGNETIC COMPATIBILITY (EMC)".
Do not position the power source and the equip-
ment on surfaces with inclination exceeding 10°
with respect to the horizontal plane.
Protect the installation from heavy rain and sun.
Do not use the power source to thaw pipes.
6.1 Electrical connection to mains
The system is provided with one single electrical connection
with 5 m cable at the rear of the power source.
Power source input cable and fuse sizing table:
Power source
Rated voltage
Voltage range
Delayed fuses
Power supply cable
WARNING
* The electrical system must be made by skilled techni-
cians with the specific professional and technical quali-
fications and in compliance with the regulations in force
in the country where the equipment is installed.
* The welding power source supply cable is provided with
a yellow/green wire that must ALWAYS be earthed. This
yellow/green wire must NEVER be used with other volta-
ge conductors.
* Verity the existence of the earthing in the used plant and
the good condition of the socket/s
* lnstall only plugs that are homologated according to the
safety regulations.
6.2 Connecting the equipment components
Keep to the safety regulations contalned in sec-
tion "1.0 SAFETY".
Connect the componente carefully, in order to
avoid power losses.
GENESIS 240 TLH
400 V ± 15%
340 - 460 V
10 A
4x4 mm2
Connection for MMA welding
The connection in the figure results in welding
with inverse polarity. To obtain welding with
direct polarity, invert the connection.
Connection for TIG welding
- Connect the gas pipe from the cylinder to the rear gas con-
nection.
In the case of TIG welding with torch provided with liquid
cooling and WU15 unit, make the following connections:
• Connect the TIG torch liquid delivery pipe to the
ting on the WU15 front panel.
• Connect the TIG torch return pipe to the
WU15 front panel.
fit-
fitting on the
19