Danger Of Fire - Futurelight PHS-265 wireless DMX Pro-Head-Spot Manual Del Usuario

The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert after every four year in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are approved by a
skilled person once a year.
Procedure:
The projector should be installed outside areas where persons may walk by or be seated.
IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not limited to)
calculating working load limits, installation material being used, and periodic safety inspection of all
installation material and the projector. If you lack these qualifications, do not attempt the installation yourself,
but instead use a professional structural rigger. Improper installation can result in bodily injury and.or
damage to property.
The projector has to be installed out of the reach of people.
If the projector shall be lowered from the ceiling or high joists, professional trussing systems have to be
used. The projector must never be fixed swinging freely in the room.
Caution: Projectors may cause severe injuries when crashing down! If you have doubts concerning the
safety of a possible installation, do NOT install the projector!
Before rigging make sure that the installation area can hold a minimum point load of 10 times the projector's
weight.
When installing the device, make sure there is no highly-inflammable
material (decoration articles, etc.) within a distance of min. 0.5 m.
Follow the instructions mentioned at the bottom of the base.
the structure (truss) to which you are attaching the fixtures is secure.
a crash or which is defective must not be used again.

DANGER OF FIRE!

Use 2 appropriate clamps to rig the fixture on the truss.
Make sure that the device is fixed properly! Ensure that
CAUTION!
The Moving-Head can be placed directly on
the stage floor or rigged in any orientation on
a truss without altering its operation characte-
ristics (see the drawing).
The fixture's base enables to be mounted in
two ways.
For overhead use (mounting height >100 cm),
always install a safety-rope that can hold at
least 12 times the weight of the fixture. You
must only use safety-ropes with quick links
with screw cap. Pull the safety-rope through
the hole on the bottom of the base and over
the trussing system etc. Insert the end in the
quick link and tighten the fixation screw.
The maximum drop distance must never
exceed 20 cm.
A safety rope which already hold the strain of
42/120 51838205_V_1_1.DOC