Publicidad
Idiomas disponibles
Idiomas disponibles
4. Click on Next in the dialog box that appears. Files are now
copied to your hard disk
5. A dialog box then tells you that the installation has finished.
Click on Finish
6. The next dialog box asks if you want to restart the computer.
Remove the CD; plug the LAN patch cable into the adapter's
RJ-45 jack; and Click on Yes.
Installation Complete:
This completes the installation. If, for any reason, you disconnect
the adapter from the computer and then reconnect it, allow the
system up to two minutes (approximately), to recognize the
reconnected adapter.
Troubleshooting
Problem
Cause
Unit does
Unit operates in half
not operate
duplex mode. Older
with Ethernet
switches may not
switch
automatically detect this
Conflict with
Cannot
connect with
previously installed
the network
network card
5
Solution
Switch must be manually
configured. See
documentation that came
with the switch for details.
Disable the previously
installed network card as
listed in the Preliminary
Steps section above.
Publicidad
