Uline H-10033 Instrucciones De Montaje página 3

3. Attach keyboard tray to mount using four M5 x 12 mm
bolts. Tighten using Phillips screwdriver. Insert four
caps to cover bolts. (See Figure 6)
Figure 6
M5 x 12 mm Bolt
4. With a second person, align keyboard tray in
desired position. Attach unit underneath the desktop
using a drill and four wood screws. (See Figure 7)
NOTE: It is recommended to position the unit
so the front edge of the keyboard tray is flush
with front edge of desktop when fully retracted.
Keyboard tray needs to be extended to attach.
NOTE: If desired, pilot holes can be created
using a drill and a 4 mm drill bit. The pilot holes
should go no deeper than 9/16".
Figure 7
PAGE 3 OF 9
ASSEMBLY CONTINUED
Cap
Keyboard Tray
Desktop
Flush
Wood Screw
1-800-295-5510
uline.com
ADJUSTING KEYBOARD TRAY
1. Loosen bolt on the underside of mount to allow
keyboard tray to swivel left or right.
2. Turn knob on the side of mount counterclockwise to
unlock tray. Adjust the keyboard tray's angle and
height to preferred setting. Turn knob clockwise to
lock. (See Figure 8)
Figure 8
Keyboard Tray
Knob
0522 IH-10033