Publicidad
Idiomas disponibles
Idiomas disponibles
ZMod Power Motion Upholstery Sofa,
Chair & Modular Operating Instructions
DANGER
– To reduce the risk of electric shock, serious injury
or death:
• Plug directly into a wall outlet. Do not use an extension cord, adapter or surge protector.
WARNING
– To reduce the risk of serious injury:
• Do not attempt to disassemble or service the pump or motor; no serviceable parts are
inside. Contact your La-Z-Boy
dealer for service.
®
• Check the condition of the power supplies, electrical cords, plugs, and connectors
often. Keep the power supplies and electrical cords away from heat sources.
Never operate the unit with a damaged power supply, electrical cord, plug,
or connector. Contact your La-Z-Boy
• The power units are intended for a single occupant, not exceeding 300 pounds per seat.
Do not operate individual seats or units with more than one occupant in or on any part
of the individual seat or unit.
NOTICE:
After 1 minute of continuous operation, allow the system
to rest for 9 minutes.
Operating the Unit:
To avoid product damage, the back recline and legrest extension features should not be operated
continuously for extended periods of time. After 1 minute of continuous operation, allow these
features to rest for 9 minutes.
Plug the power cord directly into a wall outlet. Never stretch or strain a cord.
The power features are operated by the toggles on the Control Panel located on the outside arm.
Each feature has a dedicated toggle for operation.
Press the Recline toggle to recline the back and raise the legrest. Release the toggle when
•
the back and legrest reach the desired position, or are fully reclined.
Press the Headrest toggle to adjust the headrest, release the toggle when the headrest
•
reaches the desired position or is fully open.
The Control Panel also features a Home button for personal, effortless operation and added
•
comfort. Press and release the Home button and the furniture automatically moves to its
home position.
Troubleshooting for Legrest Operation
If the legrest stops moving while closing, it may have encountered an obstruction.
1. Check to make sure there are no obstructions. Lift and hold the legrest up, look for obstructions
and remove them.
2. The legrest uses spring tension to close, and will close quickly when the obstruction is removed.
Release the legrest slowly to prevent it from slamming shut.
(ZMod Power Motion Upholstery Operating Instructions Continued)
18
®
dealer for service.
ZMod Power Motion Upholstery Sofa,
Chair & Modular Operating Instructions
USB Charging Port Instructions
Plug a small portable electronic device into the USB charging port. The USB port is for charging only
and does not have data transferring capabilities.
USB Output Specifications:
5VDC, 1.0A
Headrest Toggle
Press the Headrest toggle forward and hold to rotate the headrest forward.
Or press it rearward and hold to return the headrest. Release the button to
stop the headrest in any position, or when fully extended or fully retracted.
Recline
Return
Recline and Return
Press the Recline and Return toggle forward and hold to extend the legrest and
recline the back. Or press it rearward and hold to return the legrest and back to
the upright and fully closed position. Release the button to stop the legrest and
back recline in any position, or when fully reclined or fully retracted.
WARNING
– To reduce the risk of serious injury:
• Do not use unit if power control is damaged or wet. Contact your La-Z-Boy
Home
USB
Headrest Open Headrest Close
dealer for service.
®
19
Publicidad
