Kingfisher FPHPC100 Manual De Instrucciones página 21

Product functions
Accessory holder
Use the accessory holder (9)to store the
pressure lance (1) and the spray gun (2).
> Disassemble the pressure lance (1)
from the spray gun (2) and remove the
pressure hose (3).
> Clip the pressure lance (1) and the
trigger gun (2) onto the accessory
holder (9) (Fig. 14).
Overload cut-out
This product is supplied with a pressure switch that automatically turns off the
motor once the set pressure has been reached.
In case it is overloaded, switch the product off, disconnect it from the mains and
let it cool down for some minutes, then repeat the start - up.
If the problem recurs more than once, contact your authorised service centre.
Trigger lock
The spray gun (2) is equipped with a trigger lock (2b) in order to prevent
accidental activation of the trigger (2c).
Activate the trigger lock
> When the trigger lock (2b)is in locking position, the spray gun trigger (2c) will
be disabled (Fig. 15). Use the trigger lock, when the product is not in use,
when it is left unattended or during assembly of additional accessories.
2
Fig. 14
FPHPC100 GB GB
IE
IE
1
9
21
21
21