Kingfisher FPHPC100 Manual De Instrucciones página 24

GB GB FPHPC100
IE
IE
Operation
WARNING! Beware of kickback when pressing the trigger!
NOTE: Always keep a reasonable distance between the nozzle and
the object to be cleaned in order to avoid damage. Ask your specialist
dealer for advice if required.
> Release the trigger (2c) to stop the water jet.
Tips
WARNING! Prevent water from penetrating the air vents of the
product to minimize the risk of damage to the product and to reduce
the risk of electric shock to the operator!
> When dealing with vertical surfaces work from the bottom upwards. Rinse
from the bottom upward, use the high pressure jet at a minimum distance of
30 cm at 45° angle and then from the top downward.
> In some cases, scrubbing with brushes is needed to remove dirt. High pressure
is not always the best solution for good washing results, since it may damage
not be used on delicate or painted parts, or on pressurised components (e.g.
> Effective washing depends on both the pressure and volume of the water
used, to the same degree.
> Begin by spraying in a testing area free and clear of people and objects.
Wood and vinyl decks
> Reduce your work area to smaller sections and clean each section one at a
time for optimal results.
> Rinse at high pressure using fan spray keeping the nozzle at least 15-25 cm
from the cleaning surface.
> Maintain a further distance from the cleaning area when using jet spray.
> Caution! Increase the distance from the cleaning area for softer woods.
Cement patios, stone, and brick
> Rinse at high pressure using fan spray in a sweeping motion keeping the
nozzle at least 7-15 cm from the cleaning surface.
> Maintain a further distance from the cleaning area when using jet spray.
24
24
24
Operation