Publicidad
Idiomas disponibles
Idiomas disponibles
Check, clean accessories. Clean filter.
Dust comes out during the vacuuming. ►Filter has not been fastened correctly or is defective. ►Check to
see if filter is sitting properly; replace if required.
8.1. TECHNICAL DATA PLATE
Every machine carries a registration plate showing essential details that are necessary when contacting the
supplier/manufacturer for advice, suggestions or information on spare parts. The following details are in-
cluded on the plate:
• Manufacturer
• Model
• Serial Number
• Supply voltage
• Installed rated power
• CE symbol (built in compliance with Machin-
ery Directive 2006/42/EEC)
• Zone Atex marking of use
The identification plate is located on the control
panel or near the power cable
(Example identification plate)
8.2. TESTING
All machines are tested before packaging and delivery in order to ensure the correct function of each com-
ponent. An accurate electrical safety test is carried out in compliance with specific electric safety standards
related to:
• Ground continuity test
• Insulation resistance test between every phase and the ground
• Dielectric test
• Measurement of dispersed current
• Measurement of power and absorbed current (acceptable difference of +/-10% of rated value)
• Measurement of maximum depression and air exhaust values (tolerance of +/-15% based on temperature
values and humidity of environment)
• Measurement of maximum air absorption
8.3. SAFETY DEVICE
The vacuum cleaner has been manufactured in compliance with all legal standards for the operator's safety.
• All metal components are grounded to eliminate shock or electrostatic discharge, including the flexible
suction hose that is properly grounded. Also in this regard the choice of a suitable flexible suction hose
allows to eliminate this risk on the hose length that goes from the use area to the vacuum cleaner.
• The brakes mounted on the pivoting front wheels safely secure the machine in the place of use \where
there may be a risk of movement due to uneven surfaces or other particular working conditions.
8.
TECHNICAL DATAS
22
Publicidad
