Publicidad
Idiomas disponibles
Idiomas disponibles
EN
4
USE
4.1
Start-up
Once installation of the SIME SMART PLUS Remote Control has
been completed, proceed as follows:
– Set the main system switch to ON (on)
– From the boiler control panel, set "Stand-by" mode
ON
– The display of the remote control unit will show the following
" Main screen" .
Fri 15 May 2021
Hot water set 10°C
Winter Automatic - Set 21.0°C till 14:45
4.2
Make the electrical connections.
1
2
Power up the SIME SMART PLUS.
Choose a network name (SSID) and password of the
3
Wi-Fi network to which the system must be connected
SIME SMART PLUS
4
Check on your smartphone that there is a Wi-Fi signal in
the exact point where the SIME SMART PLUS device.
On the SIME SMART PLUS from the main page press the
5
@
key; select "Wi-Fi" and "AP mode activation". If the op-
eration was carried out correctly, "AP" will appear at the
top left-hand side of the display. If the operation was not
completed correctly, repeat the procedure of point 5 .
On your smartphone search for the Wi-Fi network called
6
"SIME SMART ##" and connect to it even if the device sig-
nals that there is no access to the Internet.
Open a Web page from the device's browser
7
10:45
and enter the address 192.168.233.1 or, alter-
natively, scan the QR Code shown here. You will
access a SIME page where you can set the cre-
dentials of the domestic Wi-Fi network to which the
SIME SMART PLUS
Press OK to confirm the settings.
The connection phase may last up to 5 minutes. The
8
icon will appear at the end if the connection was made
correctly. If not, we suggest repeating the operations from
point 5
Connecting SIME SMART PLUS to the Wi-
Fi network
(this step does not require the use of the Sime Connect
app but only a smartphone)
.
device will be connected.
.
31
Publicidad
