End Of Work Cycle; Technical Data; Accessories / Spare Parts - Velp Scientifica ECO 16 Manual De Instrucciones

the temperature of the heating block with an external 3mm probe, introducing the 3mm probe pad into the hole in the upper
part of the block
3.4 Power interruptions
The unit will register a black out or a lack of power supply as a manual stop. The work cycle will have to be restarted.
3.5 Safety features
The unit is protected against overheating by a thermostat that turns off the power supply when the temperature exceeds the
safety temperature. Temperature setting is continuously controlled by electronic equipment that stops thermoregulation if
anomalous measured are sensed. An alarm message appears on the display.

3.6 End of work cycle

At the end of the count-down the work cycle will stop automatically. To stop in every moment the work cycle turn off the
general switch. When the work session is completed, should the unit remain connected to the power supply, switch it off
using the on-off switch on the frontal panel.
4. Maintenance
No routine or extraordinary maintenance is necessary apart from periodically cleaning the unit as described in this manual.
In compliance with the product guarantee law, repairs to our units must be carried out in our factory, unless previously
agreed otherwise with local distributors. The instrument must be transported in its original packaging and any indications
present on the original packaging must be followed (e.g. palletized).
It is the responsibility of the user, to properly decontaminate the unit in case of hazardous substances remaining on the
surface or interior of the device. If in doubt about the compatibility of a cleaning or decontamination product, contact the
manufacturer or distributor.
4.1 Cleaning
Disconnect the unit from the power supply and use a cloth dampened with an non-inflammable non-aggressive detergent.

5. Technical data

Power
Dimensions (WxHxD)
Weight
Holes and diameter
Construction material
Thermoregulation
Selectable temperatures
Selectable times
Set temperature reached
Count-down
End of cycle
Overtemperature
Heating block temperature stability and homogeneity
Temperature precision
Enviromental ambient temperature
Storage temperature range
Max humidity
Pollution degree

6. Accessories / Spare parts

CA0091666 Test tube for sample decomposition 22 mm external diameter, NS 19/26 cone with glass cap
CA0091667 Condenser 200 mm type KS with 3 meters polyethylene tube
10000002 Absorption attachment for condenser
CM0091680 Set of 20 glass test tubes with internal Ø 14 mm and external Ø 16 mm
CA0091636 Holder for 12 round glass cells
A00001051 Safety shield
A00000362 Adaptor for probe Ø3mm for DK / DKL / ECO
10000667 ECO 16 Fuse 5x20 3A (230 V)
10000669 ECO 16 Fuse 5X20 5A (115 V)
10000232 Foot
550 W
168x110x269 mm
3,8 Kg
14 (Ø16 mm) + 2 (Ø22 mm)
Epoxy painted aluminum cast
Pid microprocessor
room - 160 °C
0 - 199 min. - infinite
Visual signal
Visual signal
Acoustic and visual signal
On the block at 180 °C
± 0.5 °C
± 1.0 °C
5 - 40 °C (41 - 104°F)
-10... + 60 °C (14 - 140°F)
85%
2
6