Publicidad
Idiomas disponibles
Idiomas disponibles
4. Advanced operation
4.1. TWS pairing
Simply take the earbuds out of the charging
case, or turn them on as it has been
instructed previously. The earphones will
blink red and blue as they sync with each
other automatically, and then enter into
mobile pairing mode.
Note: Before installing this product, please
make sure your device is Bluetooth
compatible.
4.2. Pairing the earbuds with your mobile device
1. Turn both earbuds On by removing them
from the charging case or pressing the
multifunction button for about 4 seconds.
Both earbuds will automatically pair.
2. Set your Bluetooth
®
"discover" the wireless earbuds.
3. Place the earbuds and your phone not more
than three feet from each other.
4. After both earbuds have synchronized with
each other, the earbud LED indicator in one
of them will turn off and the LED indicator in
the other will blink red and blue to indicate
that it has entered into pairing mode.
®
mobile device to
5. On your mobile phone, tap the newly
discovered audio device KTE-010 being
displayed in the Bluetooth
6. When the mobile device asks if you want to
pair with it, click Yes or OK to accept.
7. If you have a lower Bluetooth
may be prompted to enter the passkey
0000 (4 zeros).
8. If pairing is successful the "Your device is
connected" prompt will be heard and the
earbud LED indicator will turn off.
9. If after 60 seconds the pairing process fails,
please repeat steps 1 through 6 as
described above.
10. The earbuds will automatically go into
standby mode after a short period of
inactivity to save battery life.
11. You only need to pair the earbuds with
your mobile phone once, as they will
reconnect with memorized devices
automatically.
4.3. Using the wireless earbuds
1. Answering and ending a call
• When there is an incoming call, your phone will
ring along with a tone through your earbuds.
• Press the multifunction button twice on any
®
list.
version, you
®
Publicidad
