HAMPTON BAY 92380 Guía De Uso Y Cuidado página 11

Assembly - Hanging the Fan (continued)
6
Mounting the fan motor assembly
(standard mount)
WARNING: When using the standard ball/downrod
mounting, the tab in the ring at the bottom of the slide-
on mounting bracket (A) must rest in the groove of
the hanger ball. Failure to properly seat the tab in the
groove could cause damage to the wiring.
□
Align the locking slots of the canopy (C) with the two
screws (SS) and alignment post (QQ) in the slide-on
mounting bracket (A).
□
Push up the canopy (C) and turn it clockwise until the
alignment post (QQ) engages to the round hole and the
screws (SS) engage to the key slots.
□
Firmly tighten the two mounting screws (SS).
□
Align the oval shape on the canopy (C) with canopy
bottom cover (JJ).
□
Install the decorative bottom cover (JJ) by aligning the
cover slots with screws in the bottom of the canopy (C).
Rotate the bottom cover (JJ) clockwise to lock in place.
Assembly - Attaching the Fan Blades
1
Fastening the blade brackets to
the motor assembly
NOTE: Your fan features revolutionary advancements for
quick and easy blade installation, including an alignment
post and captive blade bracket screws.
□
Fasten the blade brackets (H) to the fan motor assembly (E)
by inserting the alignment post into the slot on the bottom
of the motor and tightening the pre-installed blade bracket
screws (LL).
□
Repeat this step for the remaining blade brackets.
SS
QQ
H
11
Please contact 1-877-592-5233 for further assistance.
E
LL
HOMEDEPOT.COM/HUBSPACE
A
C
JJ
E