HAMPTON BAY 92380 Guía De Uso Y Cuidado página 13

Assembly - Preparing the Remote Control
Preparing the remote control
NOTE: The remote control has already been paired to the
ceiling fan for your convenience. If the remote control does not
communicate with the fan, follow the pairing instructions below.
NOTE: The remote control battery will weaken with age and
should be replaced before leaking takes place, as this will damage
the remote control. Dispose of used battery properly and keep the
battery out of the reach of children.
Pairing one remote to one ceiling fan
□
Confirm that the power to the fan is off at either the wall switch or
breaker box.
□
Return power to the fan and, within 30 seconds, press and hold the
learn button for 1-2 seconds and release.
□
If pairing is successful, the blades will begin to spin and the light will
also flash.
Pairing multiple remote controls to one
ceiling fan
NOTE: The fan can be controlled by up to three remote controls.
To order extra remote controls, please call Hampton Bay customer
service 1-877-592-5233.
NOTE: The fan can only be controlled by 3 remote controls
maximum at the same time after "Learning". If you pair a fourth
remote control to the fan, the first remote control will be erased
from the receiver memory.
□
Confirm that the power to the fan is off at either the wall switch or
breaker box.
□
Turn the power to the fan on at the breaker box or wall switch and,
within 30 seconds, press and hold the "Learn" button for 10 seconds
and release. Once pairing is successful, the blades will begin to spin
and the light will also flash.
□
Repeat the above process for the remote controls you want to work
with this fan.
13
Please contact 1-877-592-5233 for further assistance.
HOMEDEPOT.COM/HUBSPACE