Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly - Attaching the Fan Blades (continued)
2
Attaching the blades to the
blade brackets
NOTE: Your fan blades are reversible. Select the blade side finish
which best accentuates your decor.
□
Mount the fan blade (F) to the blade bracket (H) by aligning the
three key-slot holes in the blade (F) with the three posts on
the top of the blade bracket (H).
□
Hold the blade (F) with both hands close to the blade bracket
(H) down firmly. Ensure the key slot holes are properly seated
on the blade bracket (H) posts.
□
While still holding the blade (F) down with both hands, firmly
slide the blade (F) until it engages in the locking mechanism
(UU). Make sure the locking mechanism (UU) at the rear of the
blade bracket (H) springs upward and butts against the edge
of the blade (F), indicating a secure connection.
□
Visually inspect the top of the blade bracket (H) to ensure the
locking mechanism is securely in place.
□
Repeat this procedure for the remaining blades (F).
Assembly - Attaching the Light Kit
1
Attaching the light kit fitter assembly
CAUTION: To reduce the risk of electric shock, disconnect
the electrical supply circuit to the fan before installing
the light fixture.
□
Connect the wires from the light kit fitter assembly (G)
to the wires from the bottom of motor assembly (E) by
connecting the molded adaptor plugs together. Carefully
tuck all wires and splices into the switch cup.
□
Place the light kit fitter assembly (G) into the motor
assembly (E), aligning the raised dimples on the top
flange of the light kit fitter assembly (G) with the
flat areas on the switch box on the bottom of motor
assembly (E).
□
Turn the light kit fiiter assembly (G) clockwise until it
stops.
F
H
UU
E
G
12
E
G
Publicidad
