STAMOS S-WIG 200 IGBT Manual De Instrucciones página 8

TIG torch:
1
1. Back cap, long
2
2. Collet
3
3. Torch handle
4
4. Collet inside housing
5
5. Ceramic nozzle
5. CONNECTING LEADS
CONNECTION DIAGRAM – MMA WELDING MODE:
1. Set the switch (10) to MMA welding mode.
2. Connect the return lead to the correct socket, marked with the number 5 on
the diagram and tighten the locking nut.
3. Then connect the welding lead to the correct socket, marked with the number
6 on the diagram and tighten the locking nut.
ATTENTION! Polarization of the leads has to be different! All polarisation
information should be shown on the packaging supplied by the electrode
manufacturer.
4. Once the machine is correctly assembled, connect the power lead and switch
it on.
CONNECTION DIAGRAM – TIG WELDING MODE:
1. Set the switch (10) to TIG welding mode.
2. Connect the return lead to the correct socket, marked with the number 5 on
the diagram and tighten the locking nut.
3. Then remove the cap and connect the welding lead to the socket, marked
with the number 6 on the diagram and tighten the locking nut. Connect the
remaining leads to the socket marked with the number 7 on the diagram –
control socket and to the socket market with the number 8 on the diagram
– gas connection socket.
4. Then connect the gas source to the connector on the back of the machine.
5. Once the machine is correctly assembled, connect the power lead and switch
it on.
6. DISPOSING OF PACKAGING
The various items used for packaging (cardboard, plastic straps, polyurethane foam) should be kept, so that
the device can be sent back to the service centre in the best possible condition in case of any problems!
7. TRANSPORTATION AND STORAGE
Shaking, crashing and turning upside down of the device should be prevented when it is transported. Store it
in a properly ventilated surrounding with dry air and without any corrosive gas.
8. CLEANING AND MAINTENANCE
• Always unplug the device before cleaning it and when the device is not in use.
• Use cleaner without corrosive substances to clean surface.
• Dry all parts well before the device is used again.
• Store the unit in a dry, cool place, free from moisture and direct exposure to sunlight
EN
14
Rev. 20.03.2017
9. CHECK REGULARLY THE DEVICE
Check regularly if the device doesn ́ t present any damage. If there is any damage, please stop using the device.
Please contact your customer service to solve the problem.
What to do in case of a problem?
Please contact your customer service and prepare following information:
• Invoice number and serial number (the latter is to be found on the technical plate on the device).
• If relevant, a picture of the damaged, broken or defective part.
• It will be easier for your customer service clerk to determine the source of the problem if you give
a detailed and precise description of the matter. The more detailed your information, the better the
customer service will be able to answer your problem rapidly and efficiently!
CAUTION: Never open the device without the authorization of your customer service. This can lead to
a loss of warranty!
Rev. 20.03.2017
EN
15