Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT PUMP WARNING AND SAFETY INSTRUCTIONS
For Installation of Electrical Controls at Equipment
Pad (ON/OFF Switches, Timers and Automation Load
Center)
Install all electrical controls at
equipment pad, such as on/off
switches, timers, and control
systems, etc. to allow the operation
(startup, shut-down, or servicing) of
any pump or filter so the user does
not place any portion of his/her body
over or near the pump strainer lid,
filter lid or valve closures. This
installation should allow the user
enough space to stand clear of the
filter and pump during system
start-up, shut down or servicing of
the system filter.
HAZARDOUS PRESSURE: STAND
DANGER
CLEAR OF PUMP AND FILTER
DURING STARTUP.
Circulation systems operate under
high pressure. When any part of
the circulating system (ie locking
ring, pump, filter, valves, etc.) is
serviced, air can enter the system
and become pressurized.
Pressurized air can cause the pump housing cover, filter
lid, and valves to violently separate, which can result
in severe personal injury or death. Filter tank lid and
strainer cover must be properly secured to prevent violent
separation. Stand clear of all circulation system equipment
when turning on or starting up pump.
Before servicing equipment, make note of the filter
pressure. Be sure that all controls are set to ensure the
system cannot inadvertently start during service. Turn off
all power to the pump. IMPORTANT: Place filter manual
air relief valve in the open position and wait for all
pressure in the system to be relieved.
Before starting the system, fully open the manual air relief
valve and place all system valves in the 'open' position
to allow water to flow freely from the tank and back to the
tank. Stand clear of all equipment and start the pump.
IMPORTANT: Do not close filter manual air relief valve
until all pressure has been discharged from the valve
and a steady stream of water appears. Observe filter
pressure gauge and be sure it is not higher than the pre-
service condition.
4
Copyright © 2022. All rights reserved • 95 North Oak Street • Kendallville, IN 46755
General Installation Information
•
All work must be performed by a qualified service
professional, and must conform to all national, state
and local codes.
•
Install to provide drainage of compartment for electrical
components.
•
These instructions contain information for a variety of
pump models and therefore some instructions may
not apply to a specific model. All models are intended
for use in swimming pool applications. The pump
will function correctly only if it is properly sized to the
specific application and properly installed.
Pumps improperly sized or installed
or used in applications other than for
which the pump was intended can result in severe personal
injury or death. These risks may include but not be limited
to electric shock, fire, flooding, suction entrapment or
severe injury or property damage caused by a structural
failure of the pump or other system component.
The pump can produce high levels
of suction within the suction side of
the plumbing system These high levels of suction can pose
a risk if a person comes within the close proximity of the
suction openings. A person can be seriously injured by this
high level of vacuum or may become trapped and drown. It
is absolutely critical that the suction plumbing be installed
in accordance with the latest national and local codes for
swimming pools.
SAVE THESE INSTRUCTIONS
Publicidad
