VONROC JS502AC Traducción Del Manual Original página 6

EN
temperature range specifi ed in the instructions.
Charging improperly or at temperatures outside
the specifi ed range may damage the battery and
increase the risk of fi re.
6) Service
a) Have your power tool serviced by a qualifi ed
repair person using only identical replacement
parts. This will ensure that the safety of the
power tool is maintained.
b) Never service damaged battery packs. Service
of battery packs should only be performed by the
manufacturer or authorized service providers.
ADDITIONAL SAFETY WARNINGS FOR JIGSAWS
• Do not work materials containing asbestos.
Asbestos is considered carcinogenic.
• Wear safety goggles, hearing protection and
if necessary other protective means, such as
safety gloves, safety shoes, etc.
• Before use, remove all nails and other metal
objects from the workpiece.
• Make sure that the workpiece is properly sup-
ported or fi xed.
• Do not use the machine without the guard.
• Inspect the saw blade before each use. Do not
use saw blades which are bent, cracked, or
otherwise damaged.
• Make sure that the saw blade is properly moun-
ted.
• Only use saw blades that are suitable for use
with the machine.
• Only use saw blades with the correct dimensi-
ons.
• Do not use other accessories than saw blades.
• Do not use saw blades made of HSS steel.
• Do not use the machine on workpieces requi-
ring a maximum sawing depth that exceeds the
maximum sawing depth of the saw blade.
• Hold the machine by the insulated gripping
surfaces where the saw blade may contact hid-
den wiring or the mains cable. If the saw blade
contacts a 'live' wire, the exposed metal parts
of the machine can also become 'live'. Risk of
electric shock.
• Let the machine run at no load in a safe area
after mounting the saw blade. If the machine
vibrates strongly, immediately switch off the
machine, remove the mains plug from the
mains, and try to solve the problem.
6
• Beware that the saw blade continues to rotate
for a short period after switching off the machi-
ne. Do not attempt to bring the saw blade to a
standstill yourself.
Kickback
Kickback is the upward and backward movement
of the saw blade when the saw blade unexpectedly
touches an object. Securely hold the machine during
use. Keep your attention focused on the operation.
Kickback is usually caused by:
- unintentionally touching hard objects or materi-
als with the rotating saw blade;
- a blunt saw blade;
- a saw blade that is not properly mounted;
- sawing into a previous cut;
- a lack of attention to the operation;
- an instable stance.
Electrical safety
Always check that the voltage of the power
supply corresponds to the voltage on the
rating plate.
• Do not use the machine if the mains cable or
the mains plug is damaged.
• Only use extension cables that are suitable
for the power rating of the machine with a
minimum thickness of 1.5 mm
extension cable reel, always fully unroll the
cable.
2. MACHINE INFORMATION
Intended use
Your jigsaw has been designed for sawing wood,
metal, plastics, ceramics, rubber, etc. to any requi-
red size and in any required shape.
2 . If you use an
WWW.VONROC.COM