VONROC JS502AC Traducción Del Manual Original página 7

TECHNICAL SPECIFICATIONS
Model No.
Voltage
Frequency
Power
No load speed
Max. sawing depth (wood)
Mitre angle
Sound pressure (Lpa)
Acoustic power (Lwa)
Vibration (wood)
Vibration (metal)
Wear hearing protection.
Vibration level
The vibration emission level stated in this instruc-
tion manual has been measured in accordance
with a standardized test given in EN 62841; it may
be used to compare one tool with another and as
a preliminary assessment of exposure to vibration
when using the tool for the applications mentioned.
• Using the tool for different applications, or with
different or poorly maintained accessories, may
signifi cantly increase the exposure level.
• The times when the tool is switched off or when
it is running but not actually doing the job, may
signifi cantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work patterns.
DESCRIPTION
The numbers in the text refer to the diagrams on
pages 2 - 3
Fig. A
1. On/off switch
2. Lock-on button
3. Speed adjustment wheel
4. Guard
5. Saw blade holder
6. Saw blade guide roller
7. Base plate
8. Hex key
9. Hex key holder
WWW.VONROC.COM
10. Dust extraction connection
11. Dust adapter
JS502AC / S_JS502AC
12. Grip
230-240 V~
3. ASSEMBLY
50Hz
550 W
0 - 3.000/min
65 mm
- 45 to 45°
Mounting and removing the saw blade
85 dB(A) K=3dB
Refer to the table below to select the required saw
blade.
96 dB(A) K=3dB
2 2
11.71 m/s K=1.5 m/s
8.81 m/s 2 K=1.5 m/s 2
Remove the guard from the machine to change the
saw blade.
Fitting a saw blade (Fig. B)
The machine is equipped with a quick blade ex-
change system.
• Turn the clamping ring (13) of the saw blade
• Insert the saw blade (15) in the saw blade hol-
• Release the clamping ring (13) to close the holder.
• Make sure when changing the saw blade that
• Before use, always check that the saw blade is
Removing the saw blade
• Turn the clamping ring (13) of the saw blade
• Remove the saw blade from its holder.
Before assembly, always switch off the
machine and remove the mains plug from
the mains.
Saw blade Material
Coarse Wood
Medium Wood
Fine Steel, aluminium, plastic
Very fi ne Wood (curves)
Always saw with guard.
holder (5) completely to the left, in order to
open up the holder.
der (5) as far as possible. The teeth of the saw
blade (15) must point upward and forward. The
smooth side of the saw blade must engage in
the slot of the guide roller (6).
the blade holder (5) is free of material debris
(such as splinters of wood or metal).
securely fi xed.
holder (5) completely to the left, in order to
open up the holder.
EN
7