Publicidad
Idiomas disponibles
Idiomas disponibles
3. Getting started:
•
Unscrew the battery compartment screw
•
Insert the AA batteries respecting the polarity
•
Close the lid and tighten the screw.
The device is ready to start listening to a machine
with the chosen contact probe: the short one for
easy to access machinery, and the long one for
spaces with limited access. For this reason, do not
direct it at any moving part of a machinery.
Please follow the steps below when setting up
the device:
•
Screw the chosen probe tip to the device and
tighten it gently.
•
Plug the cable to the headset outlet, use the
90 degrees angle jack plug side.
•
Plug the other end of the cable to the device
and secure the jack plug with the thumb screw.
•
Push the ON/OFF button for 2 seconds to turn
the stethoscope ON.
•
Direct the device at a running machine.
•
Push gently to contact the tip of the probe to
the non-movable machine area of your choice.
•
Use the desired volume level by pressing the
direct access buttons 1 or 2 for changing the
volume up or down.
•
When done, press the button OFF for
2 seconds, or leave the Stethoscope untouched
for 10 minutes (Auto OFF is 10 minutes).
•
At any time, you can press the middle button to
Mute and Unmute the Stethoscope.
4. General usage
The Stethoscope offers a wide range of volume level
to operate it. By pressing the left or right button
(button 1 and 2), the volume goes Up or Down, and
the middle button is used to Mute or Unmute.
Use the two probes depending on the ease of access
of the area where you want to listen.
The output jack plug on the side is there in order to
plug a recording device (not sold by SKF).
7
EN
Publicidad
