Never use the lock function on the gas gun, when charging.
No fume mientras replenished.
Never charge inside a building or where gasoline vapors may come into contact with an ignition source.
Keep gasoline and motor away from appliances, pilot lights, barbecues, appliances, power tools, etc.
If the fuel tank has to be drained, it will be done in the open air.
Maintenance
The engine shall stop when carrying out maintenance and cleaning operations, when changing tools and
when being transported by means other than those under its own power.
Regularly check that all bolts and nuts are tightened.
Squeeze again if necessary.
The engine must be completely cooled before storing it indoors or covered.
If the machine is not used for a period of time, refer to the instructions in this manual.
Keep or replace safety labels and instructions as needed.
Use only original spare parts or accessories.
If no original parts or accessories are used, liability no longer applies.
Replace defective mufflers.
By changing tools and being transported by means other than their own power.
Squeeze again if necessary.
The gears are delivered pre-greased. However, always make sure they are well oiled before each use.
The engine is not pre-filled with oil.
Factory-installed control devices, such as the clutch cable mounted on the handle, should not be removed
or exposed.
Only drain the fuel tank in the open air.
Gasoline is extremely flammable and fumes are explosive.
Make sure the machine is properly secured when transported on a flat bed, etc.
Reduce the throttle during engine shutdown and close the fuel valve.
Due to vibrations, it is recommended to take a break for every 30 minutes of use to avoid fat on the arms.
Assembly
Please follow the steps in the Enlightenment (pages 3-5):
(The actual model may vary from the illustration shown)
41. Contents of the box
A.
Rudder with blades
B.
Top handlebar
C.
Clutch control
D. Bottom handlebar
68