Publicidad
Idiomas disponibles
Idiomas disponibles
Wheel and Depth Spur Adjustments
Fig. 8: Use the support wheels for transport
Fig. 9. The spur can be set at different depths. The deeper it extends into the ground, the deeper the blades
will work and the slower the machine will move forward. Setting the right depth will significantly reduce the
effort required. The depth spur should always be adjusted to suit soil conditions. We recommend testing
several depths to see which one works best.
Gearbox lubrication
The gearbox is permanently lubricated in the factory, never open the
gearbox.
Engine Start and Stop
Remember: Always check the oil level before use! The oil level should always be between minimum and
max. Mark on the dipstick. Always use SAE-10 oil (0.4 0 L.). Use only unleaded E5 gasoline. Never overfill
your gas tank. Warning: Stay out of the dashed zone while starting the engine! Always start the engine from
the dotted operating zone. See fig. 13.
Starting the engine
29. Set the throttle control to the commanddor to the maximum. Figure 11/14
30. Set the shutter to the maximum.
31. Move the shutter lever all the way to the left. Figure 15.
32. The shutter is not necessary if the motor is hot.
33. Pull the starter cable to start the engine.
34. Always feed the starter cable back into the engine by hand. Figure 16.
35. When the engine starts, set the shutter to the minimum (all to the right) Slightly reduce the throttle.
Stop the engine
9.
Set the throttle control to "low" and let the engine run for approx. 30 seconds.
10. When the engine is idle, adjust the throttle control to the end point.
Vibrations can travel upwards on the controller during use. Therefore, we recommend taking a break every
30 minutes.
Cleaning
The machine should be cleaned after use. Use a garden hose to wash soil and dirt. Remove any grass, etc.
from the rotor shaft. The chassis number should only be wiped with a damp cloth to avoid unnecessary wear.
Avoid using a high-pressure washer during cleaning.
Change the Oil
The oil should be changed initially after the first 5 hours of use, and then once a year.
29. Let the engine run for 5 minutes to warm up the oil.
70
Publicidad
