Decathlon FW500 Modo De Empleo página 14

Replacing the wheel castors
The front wheel castors (608 zz) are mounted with just pressure. To remove them, you just need to
●
push them out from the inside.
In the illustra on, you can see a strut "2" between the two bearings. When reassembling, you must
●
reinsert this strut to set the correct distance between the two bearings.
Replacing the bearings of the drive wheels (fig. 8)
●
Disassembly
The drive wheel bearings (6001/12,7 2RS) are mounted by applying pressure. To remove them,
◦
you simply need to push them from the inside, using a pin dri and a hammer.
Assembly
●
Posi on a new bearing on the inner side of the hub, taking care to insert it evenly (it must be
◦
co-axial with the hub, otherwise it won't go in).
Before posi oning the two bearings, on the opposite side, you need to insert the quick removal
◦
axle into the bearing which has already been inserted, so that the axle itself acts as a guide for the
two bearings. This way, you make sure that the hub and three bearings are co-axial.
6.3 Checking the quick removal devices
The quick removal axles provided are checked and adjusted: Ø 12.7 mm x Usable L 130 mm. Nevertheless, we
recommend carrying out this check regularly during their use.
Check :
● Make sure that the "X" bu on bas been en rely released (fig. 10), once the wheel has been
assembled.
Pull the wheel towards the outside of the wheelchair (fig. 11), and the wheel shouldn't come out
●
without you pressing the bu on.
FIG. 6
(Fig. 7)
FIG. 7
FIG. 8
13