Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
Speed of the tool may be adjusted by turning the
regulator located near the air inlet.
Disconnect tool from air supply before installing or
removing backing pads or sanding disc.
INSTALLING BACKING PADS
Hold spindle nut with wrench.
Thread pad into spindle and tighten.
INSTALLING SANDING DISC
HOOK and LOOP
Center sanding pad on backing pad and apply firm
pressure.
Be sure the pad is the correct size for the tool.
A mismatch between tool and pad will cause
excessive vibration.
ZPSO4625CE Rev C
EN
EN
CHANGE THE GRIP TO FIT YOUR
HAND
PSOF4525/PSO4625/PSOF4625
3" RANDOM ORBITAL SANDER
5" RANDOM ORBITAL SANDERS
6" RANDOM ORBITAL SANDERS
A – Sized for small hand
ZPSO4625CE
B – Sized for large hand
C – Feature: Super Ergonomic Adjustable Grip
Advantage: Indexable to Multiple Positions for
Optimum comfort
Benefit: Soft Material for Maximum Absorption
1 – To re-position the grip, pull up from the front or
side and lift up from the sander
2 – Rotate grip to most comfortable position for your
hand and snap back in place on the sander
6
A
PSOF4325/ PSO4525/
B
1
C
(08/18)
(02/20)
Publicidad
