Publicidad
Idiomas disponibles
Idiomas disponibles
u Disconnect the product from voltage.
u Set DIP switches 1, 2 and 3 on bank S2 to "ON".
u Switch on the product.
u Hold the new master RFID card in front of the
RFID card reader.
u Disconnect the product from voltage.
u Set the desired maximum charging current via
DIP switches 1, 2 and 3 on bank S2.
u Switch on the product.
Deleting all programmed RFID card from the
whitelist
u Hold the master RFID card in front of the RFID
card reader for 10 seconds.
ð All programmed RFID cards will be deleted from
the whitelist, and the "Fault" LED flashes once.
ð The master RFID card will not be deleted.
Using the configuration tool to manage the
internal whitelist
Alternatively, the configuration tool can be used to
manage the internal whitelist.
1 "6.5.1 Description of the configuration tool"
[} 28]
6.6
Closing the product
The tasks described in this section may only
be carried out by a qualified electrician.
ATTENTION
Material damage due to crushed components or
cables
Damage and malfunctions can occur due to
crushed components or cables.
u When closing the product ensure that compon-
ents or cables are not crushed.
u Fix components or cables in place if necessary.
30
Fig. 16: Closing the product
u Fold the top section of the housing upward.
u Screw the top and bottom housing sections to-
gether. Tightening torque: 1.2 Nm.
Publicidad
