Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT DESCRIPTION
Submersible grinder pumps are recommended for use in basins or lift stations and are suitable for pumping
residential sewage, effluent, wastewater, and other non-explosive, non-abrasive, and non-corrosive liquids.
These pumps utilize a cutting mechanism, located on the suction side of the pump, that cuts solids into a
slurry. A semi-vortex, non-clog impeller then passes this slurry directly through the volute and into the dis-
charge line.
Some FPS IGP series grinder pumps are equipped with a float switch that allows the pumps to operate auto-
matically by cycling them on and off. The float switch is attached to the pump at a pre-determined tether
length of 9 inches (22.86 cm). Check the tether length on the pump to ensure it has not changed during
shipping.
This product is covered by a Limited Warranty for a period of 2 years from the date of original purchase by
the consumer. For complete warranty information, refer to www.FranklinEngineered.com.
Specifications
Model No.
Volts
IGP-A231-20
IGP-A231-30
IGP-M231-15
208-230
IGP-M231-30
IGP-M233-30
IGP-M463-30
460
NOTE: IGP-A models can be ordered without automatic floats.
Flow Rate
10 ft
20 ft
(3.0 m)
(6.1 m)
33 / 124.9
32 / 121.1
Amps
13.9
10
4.5
Gallons (Liters) per Minute at Height
40 ft
60 ft
(12.2 m)
(18.3 m)
(24.4 m)
31 / 117.3
30 / 113.6
Watts
HP
3200
2
1300
1025
80 ft
100 ft
(30.5 m)
(36.6 m)
25 / 94.6
20 / 75.7
10 / 37.9
PRODUCT DESCRIPTION
Phase
1
3
Shut-Off
120 ft
(ft / m)
130 / 39.6
Specifications
3
Publicidad
