ZUMEX SPEED PRO Serie Manual De Usuario página 21

SELF SERVICE TRAY TAP (44)
To mount the Self Service tap in the container, line up the rear lug and screw the floating nut on
the rear of the tap (Figure 3).
TAP OPERATION
You can make the tap work normally by pressing and releasing it to extract the juice
(Figure 14.1).
You can lock/unlock the "free spout" or "discontinuous spout" function by leaving the catch
in position "a" (free position) or in either of the 2 positions "b" for locking the relative spout
(Figure 14.2).
You can anchor the button in "free spout" position. To this end, turn the ring with the dotted/
solid lines until the solid line coincides with the glass symbol.
Release the button. This will secure it.
To release it, just press the button again (Figure 14.1).
For daily cleaning, you can remove the upper part of the tap and the inlet spout (Figures 14.3
and 14.4).
DETECTOR TUBE GASKET (46)
If required, this gasket can be removed for cleaning (Figure 3 or 4).
MACHINE SUPPLEMENT (47)
Use this supplement to raise the machine (Figure 3).
Important! The machine must never be placed on the supplement by one single person.
TANK JUICE CONTAINER (50)
Line up the two side lugs at the ends of the container and press. Pressing the side buttons may
help mount it (Figure 15).
To remove the container, just press the side buttons and pull out towards you.
TANK SUB-FILTER (51)
Place on the inside of the juice extraction container (Figure 5).
TANK/COOLER BUOY (52)
TANK MODEL
Line up the lugs of the buoy support with the holes on the lid and screw the nut (Figure 16.1)
Insert the buoy and place the lid on the tank (Figure 16.2 and 16.3).
The BUOY unit can be detached as indicated in Figure 17 for cleaning.
COOLER or TANK MODEL
Slacken the upper lugs. Line up the plate with the openings from below. Tighten the upper
lugs again (Figure 19).
TANK (53)
Use the thread to secure the Self Service tap to the Tank container. Make sure that it is in
upright position (Figure 18.1).
TANK TAP (55)
Use the thread to secure the Self Service tap to the Tank container. Make sure that it is in upright
position (Figure 18.1).
The Tank tap can work continuously or discontinuously. Just turn the handle 180º and it will be
locked when the handle is lowered, thus permitting free spout.
For cleaning, you can remove the upper part of the Self Service tap (Figure 18.2).
LEVEL DETECTOR (56)
This component only needs to be manipulated if a spare part is requested. Remember to place the
detector in the same position as the original detector. If you have a Tank machine, the detector
is located in the upper part; if you have a Cooler machine, it is located in the lower part (Figure 5
and Figure 6).
39