General Operation - ZUMEX SPEED PRO Serie Manual De Usuario

GENERAL OPERATION

Once you have installed the machine correctly and before plugging it into the mains, confirm electrical
data coincide with the electricity supply. If everything is correct, plug the machine into the mains.
To switch the machine on, press the green ON button. The LED of the ON/OFF button and the digital
display of the machine will light up.
Before operating the machine with oranges, you must calibrate it without load. Enter the Calibration
section of the CLIENT MENU, or leave the machine operating without load for approximately 1
minute until it comes to a stop.
To make sure the count is correct, you may have to adjust the Offset parameter after calibrating the
machine.
To do so, enter MENU>5.Calibration>2.Offset and adjust the value. Exit the Menu and check the count
without load, and with 2 or 3 oranges. Repeat the process again until you find the value that allows for
a correct machine count.
To avoid possible counting errors, try not to stop the machine with an orange trapped between the
upper and lower pressing units.
The orange counter is shown in all the models. (Deviation +-1%)
Remember to put a jug or glass under the juice outlet of your machine.
The machine will not work if any safety element is missing.
If necessary, you can always switch the machine off as follows:
A Release the actuator used. For example, the tap.
B Press the STOP button.
Press the red OFF button.
C
ONLY IN EMERGENCIES: Unplug the machine directly from the wall socket.
D
E If the machine does not detect oranges, it will stop approximately 60" after the last orange has
passed through.
LOADING THE FEEDER
To load the machine feeder with oranges, you can open the Feeder basket (14) door and partially
empty the box of oranges into it. Close the door and finish filling the basket.
JUICE EXTRACTION UNIT
Make sure that all the elements that permit cutting the orange, extracting the juice and collecting
it are mounted on the machine. To do this, consult the machine model purchased on the diagram
indicated in section: UNPACKING AND START-UP. ASSEMBLY AND DETACHMENT OF COMPONENTS
ACCORDING TO MODEL.
Check the state of the containers and filter to guarantee quality juice.
If you have purchased a machine with Pulp sweeper (43), use this from side to side, to deposit remains
of pulp, seeds, etc. in the waste bins.
If you have purchased a machine with SS tap (44) or Tank tap (55), read the instructions for use of the
Self Service tap in section ASSEMBLY AND DETACHMENT OF COMPONENTS ACCORDING TO MODEL.
If you have purchased an automatic filling machine, the machine will stop automatically when it
reaches maximum level. Remember to fit the Tank/Cooler buoy (2), following the assembly instructions.
You will also have to select filling quantity.
WASTE AREA
Make sure that the elements that collect the orange peel are correctly positioned.
Check if the tanks are getting full, to prevent the peel from flowing over.
You can also use the new function, WASTE LIMIT, which enables you to programme an alarm so that
the machine will stop when the waste bin is full.
You can select the number of oranges you want to squeeze before the alarm sounds. Once you have
squeezed the amount of oranges programmed, the machine will stop and a warning will appear on the
display so that the operator knows the waste bin has to be emptied.
If you have purchased a machine with PODIUM, the peel will fall directly into the Waste bin (90.4) or
Peel bucket (100.3).
To switch the alarm off, press the "OK" button for approximately 2" until it comes to a stop.
43