Preparation; Operation - ZUMEX Essential Manual De Usuario

Preparation

To start squeezing you must follow the steps below:
1
Unpack your juicer and place it on a surface as horizontal as possible.
2
Ensure that the mains power falls within the margins indicated on the
Identification Label of the machine which you will find both on the cover
page of this manual as well as on the machine itself.
3
Place the peel buckets as indicated in Fig. 1 and 4.
4
Make sure that the juice container, the filter and the sweeper unit (Versatile Pro)
are correctly positioned. and that the cover is closed and secured by the catch.
ZUMEX ESSENTIAL BASIC. Before starting the unit, place the orange feeding
tube in the position shown on Fig. 2. Use the 4 mm Allen key supplied with the
machine.
If you have acquired a juicer with a podium, you must place the juicer on the
podium, screw it as indicated in the instruction supplied on the podium. Don't
forget to secure the front wheels. Then place the hopper and the peel buckets
with an open base which you will find inside the stand (Fig. 5).

Operation

Essential Basic
Place a glass / jug under the juice outlet and press the green button (Fig. 3).
The machine will start to operate when you press the button. To stop the
juicer, press the red button.
Essential Pro y Versatile Pro
Once the previous steps have been followed, connect the connecting plug to a
socket base fitted with a standardized ground. And press the sleeve button
to start up the machine. When you turn on the machine for the first time after
purchase, a message will appear: "Select language" in order to select the
operating language of the machine.
The choice can be made using the arrows
the machine will be ready for operation in "Self-Service" mode.
and pressing "ON". Once selected,
As a general rule, to operate within the menu, we can regard the "ON" button
as accept and "OFF" as cancel.
Operating Modes with Zumex Essential Pro
Zumex Essential Pro can work in two operating modes:
Autostart: The machine detects the oranges in the feeder tube and starts up
as the oranges pass by.
Self-service: The machine starts up by activating the self-service faucet either
by pressing the faucet or by activating the switch lever; in order to be able to
operate with this switch lever see Fig. 12A and 12B. In this mode you can also
work continuously by turning the faucet block 90º (Fig. 13).
Selection of operating mode:
1
Press the MENU key for a few seconds to enter the programming mode.
2
Select the WORKING MODE option by positioning the cursors
and pressing ON to confirm your selection.
3
Select the desired working mode, Autostart or Self-Service using the cursors
and press on to confirm your selection. Press OFF several times until you
exit MENU.
Operating Modes with Zumex Versatile Pro
Zumex Versatile can operate in two working modes:
Professional: You can programme the no. of oranges to be squeezed in each
cycle using the cursors , and you can programme up to 20 oranges in each
cycle or select the 'c' option to squeeze continuously. The squeezing will start by
pressing 'ON' and it will end after ceasing to squeeze the no. of oranges pro-
grammed or if you press 'OFF'.
Self-service: The machine starts up by activating the self-service faucet either
by pressing the faucet or activating the switch lever. You can also work conti-
nuously in this mode by turning the faucet block 90º (Fig. 13).
EN
over it
25