Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Positioning and connection
Installation, electrical connections and repairs must be carried
out by a qualified technician.
Unpacking
Unpack the device immediately and make sure it has not been
damaged during transport. Should it be damaged, do not
connect, and get in touch with the Dealer.
Carefully remove the protections and the adhesives, open the
door and make sure all the components are present.
Take out the power supply cable.
Positioning
Position the device in a well ventilated area, not damp and free
(avoid cabinets with closed walls).
Keep the device away from heat sources.
Make sure the minimum distances between the device and the
walls of the room where it is placed are kept, in order to ensure
perfect ventilation of the device.
See figure.
Ventilation space:
at least 50 mm
Wiring connection
After transport, stand the device vertically, and wait for at least
3 hours before connecting it to the wiring system. Before
putting the plug into the power socket, make sure that:
•
the socket is earthed and according to legal regulations;
•
the socket is able to hold up to the maximum power load of
the machine, indicated on the Data Sheet table or on the
feature plate to the bottom right (see Overview);
•
the power supply voltage falls within the range indicated on
the Data Sheet table or on the feature plate to the bottom
right (see Overview);
•
the power socket is compatible with the plug of the device.
Otherwise, replace the socket or the plug; do not use
extensions or multiple sockets.
Dimensions of the compartment
min. 560 mm
588 mm
Here, "Push to open"
Here, "Push to close"
9
560 mm
Dimensions of
the cellar
Furniture side
area
EN
Publicidad
