Publicidad
Idiomas disponibles
Idiomas disponibles
The tester is compatible with a wide range of battery types, including Conventional,
Maintenance Free, AGM, Gel Cell, Marine Starting, Spiral Wound and Deep Cycle
(with starting rating) batteries. The tester can test these types of batteries against
several battery capacity rating systems. Below is a chart of the operating range of the
tester based on the applicable capacity rating systems:
Rating System
CCA
DIN
IEC
EN
JIS
The tester has recommended operating ambient temperature range of 32°F to 122°F.
Preparing Battery to Be Tested
Warning: Always wear eye protection, appropriate protective clothing and other
safety equipment when working near lead-acid batteries. Do not touch eyes while
working on or around lead-acid batteries.
1. Be sure area around battery is well ventilated while battery is being tested.
2. Clean battery terminals. Wire brush them if necessary. Be careful to keep
corrosion from coming in contact with eyes.
3. Inspect the battery for cracked or broken case or cover. If the battery is damaged,
do not use tester.
4. If the battery is not a sealed Maintenance Free battery, add distilled water in each
cell until battery acid reaches level specified by the manufacturer. This helps purge
excessive gas from cells. Be careful not to overfill.
5. Confirm that all vehicle accessories are turned OFF to ensure you do not cause
any arcing and that the tested battery has a nominal voltage of 12 Volts.
6. If it is necessary to remove battery from vehicle to test, always remove ground
terminal from battery first.
Testing Capacity
40-2000 CCA
25-1300 CCA
30-1500 CCA
40-2100 CCA
Over 50 Models
Publicidad
