Publicidad
Idiomas disponibles
Idiomas disponibles
Recommendation
-
It is recommended to clean the side brushes once a week with the help of the cleaning
brush.
-
Remove the side brushes by pulling them outwards and clean them regularly.
-
To ensure a perfect cleaning, it is suggested to replace the side brushes every 3 months,
depending on the frequency and type of use.
Mixed tank. Fig. 12:
-
Remove the mixed tank.
-
Open the mixed tank cover and empty it.
-
Remove the filter and filter holder as shown in the figure.
-
Use the cleaning brush to clean the inside of the mixed tank.
-
You can clean the dust compartment with water, without immersing the tank.
-
Reinstall the mixed tank on the robot vacuum cleaner.
High-efficiency filter. Fig. 13:
-
The high-efficiency filter is designed with fibres that help trap dust particles, dust mites,
pollen... It is very important to periodically clean the filter, to avoid these particles from
building up in the filter, causing efficiency loss. It is convenient to carry out this maintenance
once a week.
-
Replace the high-efficiency filter every 3 months, depending on the frequency and type of
use.
Recommendation
Dirt can be removed with a small brush or by shaking it carefully against a hard surface for
dust to fall off. The high-efficiency filter cannot be washed.
Mesh primary filter and sponge filter
The filtering system is featured with a primary mesh filter and a sponge filter, located next to
the high-efficiency filter. It is suggested to replace them either after a maximum of 160 hours
of use or when they are worn out due to operation.
Recommendation
Dirt can be removed with a small brush or by shaking carefully against a hard surface for dust
to fall off. You can also use warm water without detergents to obtain better results. Always
make sure they are completely dry before installing them again; otherwise, moisture can reach
the robot motor and damage it.
ENGLISH
ETERNAL MAX X-TREME
59
Publicidad
