Publicidad
N.B. If during transport or storage the appliance has been placed by mistake in a horizontal position or
has been turned upside down, leave for at least three hours in the correct position before switching on
the power supply.
5.
Connect the plug (do not use three-way adapters and reduction adapters) (see
figure 5).
7. CHECKING CORRECT OPERATION BEFORE USE
CHECK THAT: 1.
The plug is connected. . The refrigeration unit switch is switched on (green light on).
3
. The thermometer shows the desired temperature for the goods to be stored. . The internal lights and
5
the rotation are ON. . The door is properly closed. . The appliance is not exposed to direct sunlight or
to high-powered lamps.
7.
designed to work normally, i.e. +30°C, 55% r.h. (climatic class 4).
30 cm) in front of the motor grille to ensure sufficient airflow.
overloading the shelves and with sufficient space for cold air circulation.
8. REPLACING THE INTERNAL LIGHTS
1.
Switch off the appliance. . Undo the screws which hold the top lamp socket in place. . Remove the
protective cover. . Replace the fluorescent tube.
4
reverse order (see figure 7).
9. REPLACING THE DOOR'S MAGNETIC GASKET
1.
Open the door. . Take hold of the magnetic gasket and pull it out of the frame.
2
gasket and press it firmly down all around (see fig. 8).
Operator's guide
2
6
The room temperature does not exceed that in which the appliance is
2
5.
Reassemble by following the above instructions in
7
4
8.
There is suitable clearance (at least
9.
The cabinet is suitably filled, without
3.
Insert the new
UK
D
E
F
NL
3
P
S
DK
FIN
B
GR
CZ
EE
LV
LT
H
M
PL
SK
SLO
I
Publicidad
