6 Putting into operation
6 Putting into operation
Electric shock caused by damaged or improperly installed cables
The use of damaged or improperly installed cables may result in a potentially fatal electric shock.
► Check all live cables and connections for proper installation and damage.
► Have any damaged, deformed, or worn parts replaced by a qualified electrician only.
Fig. 5
A Cross slide
B On/off switch
C Guide arm
D Interface connector for power supply/power source communication
A
G
F
6.1 Installing the guide arms
By rotating the guide arms, adjustment can take place continuously or incrementally by means of grooves.
The roller units can be mounted on both ends of the guide arms. This means that the distance to the
workpiece can be decreased or increased.
Required tool:
EN - 14
WARNING
Overview
E
ABICAR ADVANCED 42V
E Securing lugs
F Magnetic lever
G Operating panel
Allen key AF4
Adjustment for incremental advance
► Mount the guide arms so that the grooves point
outwards.
Adjustment for continuous advance
► Mount the guide arms so that the grooves point
inwards.
► Tighten the screws with the Allen key.
B
C
D