Publicidad
Idiomas disponibles
Idiomas disponibles
ABICAR ADVANCED 42V
6.5 Changing the speed indicators (optional)
Electric shock from electronic components
Improper work on electronic components may result in potentially fatal electric shock.
► Only have the speed indicator changed by a qualified electrician.
► Switch off the device.
► Disconnect all electrical connections.
Fig. 9
A Jumper
To change the speed indicators from cm/min to inch/min, and vice versa, perform the following:
Loosen the mounting screws in order to access the rear of the operating panel.
1
Fig. 3 Operating panel on page EN-12
Set the jumper (A) to the correct position.
2
Re-secure the operating panel with the screws.
3
6.6 Connecting the power supply/power source communication connection cable
The connection cable is not included in the scope of delivery.
13 Accessories on page EN-23
Electric shock caused by damaged or improperly installed cables
The use of damaged or improperly installed cables may result in a potentially fatal electric shock.
► Check all live cables and connections for proper installation and damage.
► Have any damaged, deformed, or worn parts replaced by a qualified electrician only.
Risk of injury due to fire
A fire may occur due to improper use or connection. This may result in serious burns.
► Ensure that the operating voltage specified on the nameplate corresponds to the connection voltage.
► Insert the power supply/power source communication connection cable into the bushing.
6.7 Switching on/off the device
► To switch on the device, depress the on/off switch until it engages.
After the device has been switched on, first the current software version number will be shown on the
display. The main menu will then appear.
► To switch off the device, fully depress the on/off switch and then release it.
After approx. 6 s, the device will switch off and the display and the LED in the on/off switch will disappear.
DANGER
Rear of operating panel
WARNING
WARNING
6 Putting into operation
A
inch
cm
EN - 17
Publicidad
