Publicidad
Idiomas disponibles
Idiomas disponibles
7) Use the screws provided to mount
the push plate to the actuator.
8) Use the screws provided to
mount the flush panel to the flush
mechanism.
NO TE: If the wall thickness is within
45mm, break the connecting
rods (both red & blue) at B
section.
9) Screw the connecting rods
(matching colors) to the flush
mechanism until 18mm of the rods
is shown.
10) Repeat the process in part 6 in
reverse to install the buttons
back.
11) Press the tabs with your fingers to
snap the buttons in. Do not use a
screw driver in this operation.
12) Flush the toilet a few times for
each buttons, waiting about 30
sec. between each flush.
Installation Procedure (continued)
m
m
1 8
5
A
B
C
45 mm (B)
Publicidad
