Brinkmann 810-4580-S Manual Del Propietário página 28

Step 14
Remove the retaining nut from the
top of the thermocouple, and insert
the thermocouple into the hole in
the sear burner as shown. Reattach
nut on the other side and tighten.
Remove the pre-attached screws
from the sear burner. Use the
screws to connect the sear burner
orifi ce bracket as shown and
tighten with a screwdriver.
Connect the sear burner igniter
lead wire to the electrode on the
sear burner as shown.
Attach sear burner LED light wire to
the LED light lead coming from grill
body. Be sure to align white wires
with each other and black wires
with each other.
Step 15
Remove igniter cap and insert
a battery with the end of battery
toward igniter cap.
Ensure spring is in place inside
igniter cap. Replace igniter cap and
make sure the igniter is working
properly (Figure 1).
Place two batteries into the LED
light battery compartment, and slide
compartment into the sleeve on the
inside left panel. (Figure 2)
27
Sear Burner
Igniter Lead
Black
Wire
White
Wire
Black
Wire
LED Light
Lead
White
Wire
Figure 1
Figure 2
Thermocouple
Screws
+
-
LED Battery
Compartment
Sleeve
Thermocouple
Retaining nut
Sear Burner
Orifi ce Bracket
Igniter Cap
Battery