Publicidad
Idiomas disponibles
Idiomas disponibles
ACCESSORY
ICEMAKER ACCESSORY INSTALLATION INSTRUCTIONS
Icemaker Accessory Kit IM4D:
An IM4D icemaker accessory kit is available at extra cost.
To order, call GE Appliances at 800.GECARES
(800.432.2737) or visit GEAppliances.com. In Canada, visit
GEAppliances.ca or call 800.561.3344.
OFF
ON
Power
Switch
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT –
•
Save these instructions for local
inspector's use.
IMPORTANT –
•
Observe all governing codes and
ordinances.
Note to Installer –
•
instructions with the Consumer.
Note to Consumer –
•
future reference.
• Skill level – Installation of this appliance requires basic
mechanical skills.
• Completion time – 20–60 minutes
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not
covered under the Warranty.
49-1000557 Rev. 0
Icemaker
Feeler Arm
Be sure to leave these
Keep these instructions for
READ AND SAVE THESE INSTRUCTIONS
Damage – Shipment/Installation
If the unit is damaged in shipment, return the unit to the
store in which it was bought for repair or replacement.
If the unit is damaged by the customer, repair or
replacement is the responsibility of the customer.
If the unit is damaged by the installer (if other than the
customer), repair or replacement must be made by
arrangement between customer and installer.
ITEMS NEEDED FROM IM4D KIT
1
Icemaker
2
Installation Instructions
3
Water Valve and
Tube Assembly
5
Hex-Head Screw
for Water Line Clamp (3/4")*
WARNING
Connect to potable water supply only.
A cold water supply is required for automatic icemaker
operation. The water pressure must be between 40 and
120 psi (275-827 kilopascals)
6
Water Line Clamp
(strain relief), for house
water line
ICEMAKER
WARRANTY VERIFICATION
Date Installed
Dealer
Warranty Label
7
10 Phillips Head Screws,
for mounting icemaker (2)
(7/8")*
13 Icemaker Fill Cup
(side-mounted)
15
Publicidad
