Descargar Imprimir esta página

Haier QHE16HYPFS Instrucciones De Instalación Y Manual Del Usuario página 17

Publicidad

Idiomas disponibles

Idiomas disponibles

ACCESSORY
ATTACH WARRANTY LABEL
A label is provided with this kit to record the date of
installation for warranty purposes. Apply it to the back of
the refrigerator.
KEEP THE MANUAL
The warranty for the icemaker is printed in the manual
that came with your icemaker kit. Keep this manual
with your Refrigerator Owner's Manual.
The icemaker installation inside the freezer is now
complete. Continue to the Water Valve Assembly
section.
CAUTION
Do not place fingers or hands in the automatic icemaking
mechanism while the refrigerator is plugged in. This will
help protect you from possible injury.
It will also prevent interference with moving parts of the
ejector mechanism and the heating element that releases
the cubes, located on the bottom of the icemaker.
WATER VALVE ASSEMBLY
WARNING
To reduce the risk of death or electric
shock, you must follow these instructions:
Unplug the refrigerator before removing any panels.
Do not damage any wiring while the panel is
removed.
Replace all parts and panels before plugging the
refrigerator back in.
WARNING
ELECTRIC SHOCK HAZARD
Attach tubing clamp using existing hole only. DO NOT drill
into the refrigerator.
REMOVE THE COVER
Remove the access cover. This
requires removing screws
which attach the
cover to the back of the
refrigerator case.
Be sure to save the screws as the access cover must
be reinstalled later to ensure your refrigerator will
function properly.
49-1000557 Rev. 0
ATTACH THE WATER VALVE
Connect water tube pre-installed in the machine
compartment to water valve. Do not use the water tube
that came with the water valve. To remove the water tube
from the water valve, push the white washer towards the
water valve and pull out the water tube.
Pull out the black water tube from right side of machine
compartment. Remove the tape from the end. Insert
the water tube to the water valve all the way to the mark
0.5" from the end. Loop and tuck the rest of tube back
to compartment.
Locate the female connector plug. Plug the female
connector onto the male terminals on the water valve.
Either wire can go on either terminal.
Fasten the water valve to the cabinet by driving the
water valve mounting screw (phillips flat head screw
included with this manual in the accessory bag) into the
hole in the cabinet leg.
READ AND SAVE THESE INSTRUCTIONS
17

Publicidad

loading