Descargar Imprimir esta página

HQ-Power VDSABS15A Manual De Instrucciones página 4

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

4.
Installation
Install the device in a location where few people pass by and that is unreachable for unauthorised persons.
Make sure there is no flammable material with a 50 cm radius of the device.
5.
Overview
Refer to the illustrations on page 2 of this manual.
1
Power connector
2
Fuse holder
3
Power switch
4
Line output, XLR, balanced, + 4 dB
5
Line output, 1/4" jack, + 4 dB
6
Line input, XLR, can receive both balanced and unbalanced signals
7
RCA (R/L) input jack, can receive both balanced and unbalanced signals
8
Microphone input jack, 1/4" jack, can receive unbalanced signals
9
Microphone input jack, XLR, can receive balanced signals
10
Volume control of MIC input
11
Volume control of RCA line input
12
Adjusts the output level or volume
13
High tone level control, 12 dB raising attenuation at 3.5 kHz
14
Low tone level control, 12 dB raising attenuation at 100 Hz
15
Input signal overload indicator
6.
Operation
1. Make sure the power switch [3] is set to off ("0").
2. Plug in the power cord [1].
3. Set the power switch [3] to on ("1"). The device starts operating.
4. Set the power switch to off ("0") to stop the device.
7.
Cleaning and Maintenance
All screws should be tightened and free of corrosion.
The housing, visible parts, mounting supports and the installation location (e.g. ceiling, suspension,
trussing) should not be deformed, modified or tampered with e.g. do not drill extra holes in mounting
supports, do not change the location of the connections.
The electric power supply cables must not show any damage. Have a qualified technician maintain the
device.
Disconnect the device from the mains prior to maintenance activities.
Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
There are no user-serviceable parts.
Contact your dealer for spare parts if necessary.
8.
Technical Specifications
woofer size
tweeter size
impedance
amplifier
power supply
frequency response
sensitivity (1W/1m)
dimensions
weight
V. 02 – 24/09/2013
VDSABS15A
15" (38 cm)
1.35" (3.5 cm)
4 ohm
180 W (120 Wrms)
230 Vac
40 Hz - 18 kHz
99 dB
720 x 495 x 365 mm
28 kg
4
©Velleman nv

Publicidad

loading