Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
Symptom
Sound cannot be heard.
"MISWIRING CHECK WIRING
THEN PWR ON" appears.
"PROTECTING SEND SERVICE"
appears.
• Sound cannot be heard.
• The unit does not turn on.
• Information shown on the
display is incorrect.
The unit does not work at all.
• Radio reception is poor.
• Static noise while listening to
the radio.
Disc cannot be ejected.
Noise is generated.
Tracks do not play back as you
intended them to play.
"READING" keeps flashing.
Elapsed playing time is not
correct.
Correct characters are not displayed
(e.g. album name).
"NA FILE"
22
Remedy
• Adjust the volume to the optimum level.
• Check the cords and connections.
Turn the power off, then check to be sure the
terminals of the speaker wires are insulated
properly. Turn the power on again.
Send the unit to the nearest service center.
Clean the connectors. ( 2)
Reset the unit. ( 3)
• Connect the antenna firmly.
• Pull the antenna out all the way.
Press and hold M to forcibly eject the disc. Be
careful not to drop the disc when it is ejected. If this
does not solve the problem, reset the unit. ( 3)
Skip to another track or change the disc.
Playback order is determined when files are
recorded.
Do not use too many hierarchical levels or folders.
This is caused by how the tracks are recorded.
This unit can only display uppercase letters,
numbers, and a limited number of symbols.
Make sure the disc contains supported audio files.
( 21)
Symptom
Remedy
"NO DISC"
Insert a playable disc into the loading slot.
"TOC ERROR"
Make sure the disc is clean and inserted properly.
"PLEASE EJECT"
Reset the unit. If this does not solve the problem, consult
your nearest service center.
"READ ERROR"
Copy the files and folders onto the USB device again. If this
does not solve the problem, reset the USB device or use
another USB device.
"NO DEVICE"
Connect a USB device, and change the source to USB again.
"COPY PRO"
A copy-protected file is played.
"NA DEVICE"
Connect a supported USB device, and check the
connections.
"NO MUSIC"
Connect a USB device that contains playable audio files.
• Reconnect the iPod.
"iPod ERROR"
• Reset the iPod.
• Sound cannot be heard
• Reconnect the Android device.
• If in [HAND MODE], launch any media player
during playback.
• Sound output only
application on the Android device and start playback.
• If in [HAND MODE], relaunch the current media player
from the Android
device.
application or use another media player application.
• Restart the Android device.
• If this does not solve the problem, the connected
Android device is unable to route the audio signal to
unit. ( 21)
• Make sure KENWOOD MUSIC PLAY APP is installed on
Cannot playback at
[BROWSE MODE].
the Android device. ( 7)
• Reconnect the Android device and make the appropriate
setting in [ANDROID SETUP]. ( 7)
• If this does not solve the problem, the connected
Android device does not support [BROWSE MODE].
( 21)
Publicidad
