Parkside PBSD 600 A1 Traduccion Del Manual De Instrucciones Originale página 34

Removing the dust extraction adapter and
reducer for an external extraction appliance:
♦ Pull off the hose of the dust extraction appli-
ance.
♦ Remove the reducer
tion.
♦ Pull the dust extraction adapter
the connection .
Working procedures
A light grinding pressure is sufficient:
■ Apply minimal pressure when grinding. The belt
grinder's own weight is sufficient for a good
grinding result. In addition, working this way
helps to reduce the wear on the abrasive belt
and the surface of the workpiece will become
more smooth.
Removal and surface:
■ The material removal rate and surface quality
are determined by the belt speed and grain
strength of the abrasive belt
section "Selecting speed and abrasive belt").
Grinding:
■ Place the appliance on the workpiece when
switched on and work at a moderate feed rate.
Guide the grinder in parallel and overlapping
sanding motions over the workpiece. To avoid
unpleasant transverse grinding marks, always
sand in the direction of the grain. After complet-
ing the task, lift the appliance from the work-
piece and then switch it off.
NOTE
► Always hold the appliance firmly with two
hands while working.
PBSD 600 A1
for external dust extrac-
upwards off
(see also the
Use
Switching on and off
While operating the belt grinder, you can choose
between instantaneous and continuous operation.
Switching to instantaneous operation:
♦ Press the ON/OFF switch
Switching off instantaneous operation:
♦ Release the ON/OFF switch
Switching to continuous operation:
♦ Press the ON/OFF switch
and then press the lock button
Switching off continuous operation:
♦ Press the ON/OFF switch
it.
Emptying the dust collector
The dust collector should be emptied after every
10 minutes of operation at least.
♦ Pull the dust collector
"Attaching/removing a dust extraction unit")
♦ Shake the dust collector
to empty it.
♦ Fit the dust collector
ance.
.
.
, keep it pressed in
.
and then release
off (see section
over a rubbish bin
back onto the appli-
GB │ MT │
31 ■