Velleman DVM1200 Manual Del Usuario página 5

c. Keypad
Key Symbol
Ω
A mA μA
SELECT
Power-off
HOLD/LIGHT
V~, V
RANG
A, mA, μA
REL
MAX/MIN
V~, A, mA, μA
Hz/DUTY
4. Operating Instructions
a. General Functions
 Data Hold Mode
The data hold function makes the meter stop updating the display. The meter switches to the manual ranging
mode when enabling this function. This function can be cancelled by changing the measurement mode or by
pushing the RANG or HOLD/LIGHT key again.
To enter the mode:
1. Press the HOLD/LIGHT key.
2. A second short press returns the meter to the normal mode.
 Manual Ranging and Autoranging Modes
* In autoranging mode, the meter selects the best range for the detected input. This allows you to switch test
points without having to reset the range.
* The manual ranging mode allows you to override the autoranging mode and to lock the meter in a specific
range.
* The meter defaults to the autoranging mode in measurement functions that have mode than one range. The
meter displays
1. Press RANG to enter the manual ranging mode. Each press on the RANG key will increase the range.
NOTE: If you manually change the range after entering the data hold mode, the meter will exit this mode.
2. Hold the RANG key pressed to exit the manual ranging mode and to enter the autoranging mode.
 Battery Saver
Turn on the meter. The meter turns off automatically after approximately 30 minutes. Press HOLD/LIGHT or
rotate the rotary switch to reactivate the meter. Hold SELECT pressed to disable the battery saver function.
DVM1200
Switches between resistance measurement, diode test and continuity check.
Switches between DC and AC current.
Disables the auto power-off function.
Press to enter and exit the data hold mode. Press and hold it for 2 seconds to
switch backlight on or off.
Press to enter the manual ranging mode.
, Ω,
Press to browse through the available ranges.
Press and hold for 2 seconds to return to autoranging mode.
Press to enter and exit the relative measurement mode.
Maximum/minimum value measurement (except Hz/duty, capacitance)
Press to enter the max/min mode.
Press again to display the max value.
Press again to display the min value.
Press to start frequency counter. Press again to enter duty cycle mode and press
again to exit.
appears on the display.
when in autoranging mode.
Description
- 5 -
VELLEMAN